Skip to main content

Chris LaMothe

Search This Blog

e-30 fuel rail on early e-21 manifold with Bosch EV-14 injectors

November 20, 2010

Get link
Facebook
X
Pinterest
Email
Other Apps

Get link
Facebook
X
Pinterest
Email
Other Apps

Comments

Popular Posts

Openmediavault 0.6 kralizec on Netgear Stora

How to install Openmediavault 0.6 Kralizec from start to finish on a Marvel Kirkwood such as the Netgear Stora Needed - Netgear stora or similar serial console cable Step 1 - Modify u-boot I used the stora u-boot from Doozan forum, Thanks Bodhi uboot Using a tftp server, I like Serva Setup your tftp server's ip address and your stora for me My laptop is running at 192.168.2.91 and DNS320 at 192.168.2.88 setenv serverip 192.168.2.91 setenv ipaddr 192.168.2.89 saveenv reset Interrupt the boot again. tftpboot 0x800000 uboot.2014.07-tld-1.netgear_ms2110.mtd0.kwb nand erase 0x0 0x80000 nand write.e 0x800000 0x0 0x80000 reset Step 2 - build main drive I happen to have a 500G drive. root@debian:~# fdisk /dev/sda Command (m for help): p Disk /dev/sda: 500.1 GB, 500107862016 bytes 255 heads, 63 sectors/track, 60801 cylinders, total 976773168 sectors Units = sectors of 1 * 512 ...

ER40 Collet chuck with pass through on a South Bend 9a lathe

Tom Rafalski at 02again (www.02again.com) let me get my hands on a test unit for an ER40 Collet chuck intended for a South Bend 9a lathe. This allows you to use the full through and hold up to 1" of material. The chuck is threaded for the nose of the South Bend. (1 1/2-8) I've been wanting a better system for holding material. My ER40 collets hold a wider range of materials much tighter than my 5c or 3c collets. Currently the best available is a MT3 collet chuck which doesn't allow a through hole. In order to give myself an idea what the runout was I tried to create an ideal runout test given the age of my old South Bend 9a lathe. I recognize the age and accuracy of this old lathe is questionable. In order to remove as much of that as possible, I am going to do a dynamic runout test (running) rather than a static test. There are many factors which play here. I spent some time looking into the ANSI s...

LED neon sign replacement

The Challenge I was challenged with finding a way to encorporate the energy savings and flexibility of LED into museum exhibit's at Zimmer Children's Museum. The exhibit is a pinball machine that spans 2 floors of the Zimmer Children's museum. The Solution LED neon Flex was used to replace the old neon tubes. Neon Flex is a LED string embedded in a durable plastic case. It can be snapped into aluminum rails to form any desired shape. At 1.0A per 30 ft of light, it will save a considerable amount of electricity. The difficulty in this setup is reaching the neon tubes. In order to access the top of the pinball machine, I had to rent a 40 ft scaffolding which barely reached the top. Each of the 24 individual glass neon tubes were removed and replaced with LED neon. T The Result After the difficult and strenuous installation the final look of the LED neon is much brighter than the old glass neon tubes. The energy saving is conside...

Powered by Blogger